BridgePoint Green Balance Neutralising Carpet Rinse 1gal

Description 

Bridgepoint Systems introduces Green Balance, a line of carpet cleaning products that are truly better for the indoor and outdoor environment as well as cleaning technicians. The Green Balance line will also accomplish the most important task of all - cleaning dirty residential carpets! All Green Balance products use readily biodegradable surfactants and contain no solvents (e.g., alcohols, glycol ethers, terpenes). They contain no known carcinogens, are nontoxic and are ideal for cleaning in homes with chemical sensitivities because they contain no added fragrances or dyes. Bridgepoint insisted that ingredient suppliers could back up their green claims with solid science. They then tested for cleaning effectiveness in their own laboratory and in-field testing. But they didn't stop there! Formulas were then submitted to a leading independent testing laboratory to scientifically measure the level of actual soil removal and to ensure that the products did not contribute to rapid re-soiling - earning them the Carpet & Rug Institute's Seal of Approval. The result? Green cleaning solutions that have the best presently available science backing them up!

A mildly alkaline traffic lane cleaner that uses advanced surfactant technology instead of solvents to rapidly dissolve tough oil-based soils. Safe for wool and all synthetic carpets.
 

Are Green Balance products for filthy restaurants? Of course not. But they are perfect for cleaning even the dirtiest residential carpets leaving them looking, feeling and performing at their very best! Want to know more? 

Dilution Ratio: 1:32
RTU pH 8.5

Directions

1. Always pretest for colourfastness in an inconspicuous area.
2. For best results with extreme soiling conditions, mix one-part chemical with 21 parts hot water (6 ounces of solution to one gallon of water.) For normal soiling, mix one-part chemical with 32 parts water (4 ounces of solution to one gallon of water), for application with a Hydro-Force Injection Sprayer, Dilute 1 part GB Prespray to 1 part water in the 5 quart container. Set the sprayer at a 1 to 16 dilution. For use with regular 1-8 Hydro-Force, dilute 1 part GB Prespray to 3 parts water, then apply at a 1 to 8 dilution (final dilution 1:32).
3. Apply with an electric, battery-powered, pump up pressure, or injection sprayer with an even, overlapping light misting across the area to be cleaned.
4. For best results, allow the mixed solution to dwell on carpet for 5-10 minutes before extraction with hot water